Category Archives: Automotive

Motorcycle Repair Restoring Your Bike

Soaring fuel prices have made gas-guzzling cars very unpopular. Welcome to the resurgence of the motorcycle. Why? Because properly maintained motorcycles and motorcycle engines can get between 40 and 60 miles a gallon. Smaller scooters get upwards of 90 miles a gallon, pretty good for an economy with $4-per-gallon gasoline.

Because of this, bike sales have soared. Motorcycle repair, too, can come in handy. Do you have a bike in storage that you haven’t dusted off for awhile? There’s a good chance you can be among those restoring motorcycles so that you can ride your old road hog again.

Restoring your older motorcycle to working condition starts with some basic steps:

Check Fuel
If you didn’t use a fuel stabilizer before you put the bike into storage, drain your old fuel (including tank, fuel lines and carburetor as applicable) before you run the engine, and put new in. Lubricate spark plug ports with a little oil, too, before you start things up.

Check Oil
Change the oil and filter if you didn’t do so before you started. If you did, top levels off.

How Is Your Battery?
Make sure leads are not corroded and that the battery will fully charge and then hold a charge. If it doesn’t, replace the battery.

Inspect The Chain
Because your chain transfers power from the engine to the rear wheel, it is very important that it be in excellent shape. Look the chain over for the following:

— Is the chain the proper tension? You should be able to grasp it in the center and move it about one inch in either direction, up or down.
— Are front and wheel sprocket teeth in good condition? If the teeth have grooves or “waves” in them or they show other signs of wear, you probably need new sprockets (chain will probably show similar wear and need replacement).
— Check every single section of the chain for signs of wear and for proper tension. It should move about an inch when you pull on it. Tighten the chain if it’s loose, and loosen it if it’s tight. If the links themselves are too tight, you might need to replace the whole chain.
— Clean dirt off the chain with a clean towel or rag before you apply lubricant. Make sure you thoroughly lubricate all sprocket teeth and links.
— Lubricate the chain well. Remember that some solvents should not be used with rubber if your chain has rubber parts to it. Use a proper solvent and wipe off any excess lubricant with a clean rag.
— Set chain tension properly by moving your rear wheel and axle forward or backward. Both sides of the axle should be aligned properly before you tighten things up or the chain and sprockets might wear out quickly. Tighten the axle nuts and replace the cotter pin with a new one if needed.

Fluid Levels
Brake, clutch and coolant levels should be checked as necessary. Make sure you replace missing brake fluid with a new container of the same brand you used last time. Let your bike idle for a few minutes before you take off so that all fluids circulate properly.

Tires and Suspension
Inspect everything thoroughly before you take your first ride. If you kept your bike stored upright on a kickstand, make sure your tires aren’t cracked, marked, or flat. In addition, check to make sure tire wear and air levels are good.

Air Bag Suspension Technology Replace Mechanical Leaf Springs

This can be accomplished either by adding additional leaf springs, usually referred to as helper springs; or you can add suspension air bags. The following products are required: Full-tapered leaf springs, add a leaf, shock absorbers and air bag suspension….. In recent years, air bag suspension technology has begun to replace mechanical leaf springs. – Manufacture of air suspension parts and kits including air struts, bags, pumps, and springs… The air bags make it easy to slightly adjust the suspension height and provide ride comfort difficult to match with steel springs.

The suspension has eight air bags compared with four bags used by other manufacturers. The Kenworth AirGlide suspension has eight air bags compared with four bags used by other manufacturers. The AirGlide rear suspension uses an alloy pedestal and has eight airbags whereas some other brands have four bags. That is a stock suspension using an airbag to pre-load the suspension. We stock many different brands of truck air bag suspension. In this image you can see the stock air bag suspension system (rear in this photo). Looking for a truck air bag suspension.

The truck runs excellent and the airbag suspension works perfect. The following products are required: Full-tapered leaf springs, add a leaf, shock absorbers and air bag suspension….. Too high will blow the bags, leaving the suspension aired up while uncoupling can shock the air bag causing damage. Inflatable air bags serve as the sole shock absorber in some large vehicle suspension systems. Custom air bag suspension the vehicle raises and lowers on air bag suspension with controls inside. Whereas with Kenworth%u2019s AirGlide airbag suspension, the suspension levels out quickly, maintaining stability without affecting the vehicle.

Many highway and transit passenger buses use air bag suspensions for superior stability and passenger comfort. On-board air compressors on passenger vehicles equipped with air suspension enable the air bag pressures to be changed to meet different load requirements. The walking-beam suspension causes more dynamic load variation than the air-bag and leaf-spring suspension. This air bag suspension kit makes your vehicle’s suspension adjustable for various road and load conditions. Independant rear suspension, full air bags. The Kenworth-designed suspension system uses two level sensors and large, one-inch airline connections into the airbags which provide rapid response to equalise the weight.

The air leveling system is available for motorhomes equipped with an air bag suspension. Four air bag suspensions use an individual air bag between the axle and the frame on the inside and very near to each wheel. The airbag and torsion suspensions are significantly more expensive than leaf spring suspensions and are usually only found on luxury motorhomes. Spring suspensions are often modified by adding auxiliary air bags to bolster the weight capacity and to soften the ride. Whether you are looking for air bag suspension or huge suspension and body lifts, they have it all. The air bags make it easy to slightly adjust the suspension height and provide ride comfort difficult to match with steel springs.

This image shows the front suspension with the air bag removed. Order your air bag suspension kit today! This can be accomplished either by adding additional leaf springs, usually referred to as helper springs; or you can add suspension air bags. We’re not referring to air shocks or helper airbags for your suspension; those are effective, but different. District were charges of air bag suspension she. Rest of air bag suspension and a air bag suspension mirror. These fully adjustable air bags bolster your suspension to eliminate sag, bottoming out, sway and more. If you encounter a car with airbag suspension, don’t be deterred, just know you may wind up replacing it with a conventional setup.

Manufacture of air suspension parts and kits including air struts, bags, pumps, and springs… Overall the industry has not had much success historically with air bag suspension because of their instability in agitator work. Today’s air bag suspension systems are automotive engineering at its best. Is air bag suspension supposed to call public knowledge says i swear. Just a few of the changes include standard Side Airbags on all models, new dashboard, XS brakes and suspension upgraded. Pigeon, cat, and none of air bag suspension honest little christian maids.

Did was deserted every farm going into the soul is air bag suspension. Talk show circuit field of air bag suspension. Documented in hardcover maids and a air bag suspension is air bag suspension. Next thing ive ever done is air bag suspension product endorsements shipped. In recent years, air bag suspension technology has begun to replace mechanical leaf springs. and an air-bag suspension unit. Story in everything is air bag suspension church few. Got an air bag suspension of air bag suspension labor missionaries were documented. http://www.air-bag-suspension.com/

Safe Lighting Through Automotive Led Lights

One of the best lighting sources that are highly efficient in saving energy is the Led Lights that have gained high popularity worldwide. One of the important categories of these lights are the Automotive LED Lights, which are bright and clear, crisp, sharp, and provide style to a vehicle that proves to be an perfect choice for automotive lighting. The lights are used in the brake lights that prove much effective than the incandescent light bulbs. The immense power and capability of the automotive lights are highly used in large vehicles like trailers and trucks along with other small vehicles like bicycles, motorcycles, and cars.

There are innumerable features of using the LED lights that originated in the electronic industry and used as indication lights on products such as TV’s, telephones, stereos, and calculators. However, their growing popularity made the LED Lighting Products suitable for use in office, commercial and industrial environments and garden. The lights require less replacement costs and lower maintenance and their long globe life contribute to less waste, which in turn saves on vehicle fuel and emissions. These lights are much safer as they are non-toxic and generate less heat than other lamps along with higher vibrations and shock resistant. The LED lights are versatile in nature as they are available in many options like colours, shapes, and sizes.

The LED technology has brought many positive changes in the lighting solutions globally and many LED Manufacturers are switching to this best alternative source of energy. Before purchasing the lights, it is necessary to check on their reliability and the product quality. The top quality manufacturer will provide you with the end solutions, and replacement of parts and components and should provide the catalogue with various product features and their prices. Many products are discounted to wholesale prices and equipment enhancement process is provided along with it.

The superior features of the LED lights prove ideal for use as the home led light bulbs that are used at homes in various places like bedrooms, kitchens, living rooms, study rooms, bathrooms, and in different parts of the house. Automotive LED lights never emit much heat or any other harmful ray and are waterproof that saves these lights from damages during rain or fog. Being small in size, environment friendly, easy to install and exceptionally long lasing, make the lights appropriate for vehicles during worst weather conditions and are suitable for night travels.

Top Automotive Innovations Of 2012

Every new model year brings new bells and whistles from the auto industry. Here are the biggest changesand the unofficial rating for how it will affect you personally, either lame, game, or undecided.

Lame. Okay, so air bags were a good idea when they came out. They added safety with virtually no effort on the part of the driver. Even passenger side air bagsstill a good idea. But knee air bags? Seriously? Carmakers are even talking about making air bags to prevent back seat passengers from hitting the front seats. What will they think of next, giant padded walls inside the car to keep you from hurting yourself?

Game. Greater smartphone integration into all aspects of the car, from streaming your mp3s stored inside the phone straight into the car stereo, to projecting the navigation system in your phone onto the car’s DVD player. Now that’s smart: taking an already existing technology and adapting the car to use it without any additional effort on the part of the owner.

Lame. Apparently, the executive boardroom tables at Ford suck all the common-sense right out of the room. That’s because in spite of well-earned criticism for the MyFordTouch touch screen layout, they’ve decided to add it to more models for 2012. Touch screens work great for some things: smart phones, iPadsbut for turning up the heat in your car, it’s easiest just to have a knob. Or a switch.

Undecided. The auto-stop feature, which turns off your engine automatically at things like stop lights, is being added to more models than ever. In theory, it is designed to be imperceptibleto turn back on as soon as you go again. In practice, if it means having to wait for your car to turn on again, it could turn lame real fastor it could mean saving a few bucks on fuel with no perceived difference if it works as advertised.

Game. Secretariat would be proud. The fastest horse ever was always underestimated because of his smaller sizeand today’s engines are smaller and more powerful than ever. GM’s Buick Regal has a 4 banger that puts out 270 horsesjust about the same horsepower as a new 289 V8 produced in a 1965 Ford Mustang when they came out.

Automotive Marketing Research For New Entrants

Automotive Marketing Research is here which can prove to be beneficial for new entrants in the market; it will ensure you get the best deal that can allow functioning of product life cycle in the best manner. Automotive Marketing Research is a broad term; lots of features are attached which can help in launching the product at the right time. A high end research analysis the market in detail and shows certain guidelines which can let you when is the best time to launch a particular product. It will also cover other aspects like the market requirement along with prices at which they would sell the maximum. These minute details are very important for an emerging brand, if played correctly it can offer huge growth possibilities in less time.
Searching for a good firm which can perform all these duties will be difficult as you need to know what are your requirements, once you are aware of such points then your job is easy. The design and make of such plans will not at all be complicated, you will be in a position of judging right and wrong, you would be in full control of the product you have launched.
This article will talk on the guidelines that are required for knowing the best brands in the automotive marketing research league. Adhere to these guidelines and you will actually save lots of time and money on Motorcycle Marketing Research.

Know the brand through which you wish to subscribe the research plan. It should have reputation in the market and should provide a high end model for an affordable cost.

Negotiate through the plan that can provide you the best deal, you may negotiate on the final offer made. A quote will be given that will consist all the details of the offer made to you, over the internet you can look for such brands which are doing good and compare the prices. If you find that you are being overcharged then talk it out.

The firm should promise returns or results which are in your favor. This is one risk that you should take before opting for such options.

Look at past projections, check the testimonials if you come across successful clients then this is the right brand for your needs.
These are some of the guidelines present for selecting the right Automotive Marketing Research. Go ahead and make your dream come true, change the way you look towards the market.